Which river of Rajasthan is called beheaded river?

Where is the first Biological Park established in Rajasthan?

Who is the Chairperson of District Planning Committee in Rajasthan?

Crescent shaped sand dunes are known as -

It was the reign of Rai Singh, the ruler of Bikaner -

Who is recognized as the folk goddess of Alwar region?

Which ruler is called the 'Hindupat' in the history of Rajasthan?

Who wrote a book entitled 'Rajput painting' in 1916 AD?

Which princely state of Rajasthan provides protection to blue pottery?

Folk dramatist Nanuram is considered to be the main founder of which Khayal?

Where oxy-zone park is developing in Rajasthan?

Which one of the following Mountain Peak is not located in Sirohi District?

Nathra - ki - Pal is famous for which mineral?

When was the Divisional Commissioner System revived in Rajasthan?

How many posts of Judges are sanctioned in Rajasthan High Court?

When was the Revenue Board established in Rajasthan?

Chappan ka maidan is a part of -

The place Kolu village is associated with which Folk Deity?

Which one of the following (Mineral – Mining Area) is not correct matched?

Som - Kagdar Irrigation Project is situated in which district?

The largest Agro- Climatic region of Rajasthan is -

In which language the "Vansha Bhaskar” was written? 

Indian Railway Research and Training Center is located in?

Which of the following cities is not located on National Highway 8?

When was Rajasthan State Road Transport Corporation established?

National Highway 44 (NH 44) passes through which district of Rajasthan?

Find the head lost due to friction in a pipe of diameter 300 mm and length 50 m, through which water is flowing at a velocity of 3 m/s using Chezy's formula for which C = 60

What is the bulk modulus of elasticity of a liquid which is compressed in a cylinder from a volume of 0.0125 m³ at 80 N/cm² pressure to a volume of 0.0124 m³ at 150 N/cm² pressure?

If the pressure heads at the different sections of the pipe are plotted to scale as vertical ordinates above the axis of the pipe and all these points are joined by a slopping straight line, which is known as

Two reservoirs are connected by two pipes P and Q. The pipes have the same diameter and length and are placed in parallel. If the friction factor of P is 16 times that of Q, then the discharge in P to that in Q is

Assertion (A) : Loss of head at a sudden contraction in a pipe is smaller than the loss at a sudden expansion in the pipe.
Reason (R) : Increase in turbulence level is higher at a sudden expansion than at a sudden contraction.

Match List-I with List-II and select the correct answer :

In a 90° triangular notch, the error in the estimated discharge for a given head due to an error of 2% in cutting the vertex angle is 

Statement (S1) : The integration of differential form of Euler's equation of motion yields to Bernoulli's equation.

Statement (S2) : Euler's equation is based on the assumption of conservation of mass.

Consider the following velocity profiles in a pipeline:

Among these profiles, the momentum correction factor would be

Statement (S1): The negative derivative of velocity potential function with respect to any direction gives the fluid velocity in that direction.
Statement (S2): The partial derivative of stream function in any direction gives the velocity component in that direction.

Match List-I with List-II and select the correct answer using the code given below the lists:

Consider the following statements in respect of two-dimensional incompressible flow with velocity components u and v in x and y directions respectively :

A hydraulic press has a ram of 200 mm diameter and a plunger of 25 mm diameter. When the force applied at the plunger is 50 N, the weight lifted by the hydraulic press will be nearly

An open rectangular tank of dimensions 4m × 3m × 2m contains water to a height of 1.6 m. it is then accelerated along the longer side. What is the maximum acceleration possible without spilling the water?

An open cylindrical tank 100 cm diameter and 1.5 m high contains water upto 1.2 m depth. If the cylinder is rotated about its vertical axis, what is the maximum angular velocity (in radians per second that can be attained without spilling any water? (Take g = 10 m/s²)

If pressure head of water is 100 m and specific gravity of kerosene is 0.81, what is the pressure head of kerosene?

Which one of the following statement(s) is/are correct?

When one of the following expresses the difference in the pressure at the floors of the tank shown in the figure?

where ρ₁, ρ₂ and ρ₃ are the densities of the diffent fluids