A sample of a metal is tested in tension, and it is found that there is a strain of 0.0080 at a corresponding stress of 450 N/mm². On the removal of the load a permanent strain of 0.0015 is found to be present. The value of modulus of elasticity for the metal

The reservoir for irrigation may be planned with the value of design yield of about ____ times higher than the firm yield.

What is the ratio of most unfavourable slenderness of each member between the intermediate weld connection of two channel section connected back to back if the most unfavourable ratio of slenderness of the member as a whole is 90?

The segment BC shown in pressure void ratio curve for remoulded soil sample represents

Which of the following method is suitable for forecasting the population of those towns and cities whose development is likely to place according to the national growth of country?

Gale's method of traversing consists of plotting the points by:

The suitable contour interval for a map with scale 1 : 10,000 is

Which of the following corrections is relevant with regards to trigonometric levelling?

The Bligh's creep coefficient for light sand and mud is:

When water flows over a rectangular suppressed weir, the pressure beneath the nappe is

The reciprocal theorem of Maxwell is valid for structures:

In reinforced brickwork slabs, the diameter of main reinforcement shall, preferable not exceed

To prevent lateral movement of stones, which of the following joints is used? 

When the stones are used directly obtained from quarry, the masonry is called- 

A strut is a structural member subjected to

Which type of flooring is suitable for use in churches, theatres, public libraries and other places where noiseless floor covering is desired?

What paint is applied on steel and NOT enclosed in concrete? 

As per IS 1708 : 1969, what should be the size of the sample for the specific gravity test for timber?

When percentage of mica present in sand is large it: 

The total count of bacteria in potable water should not exceed _______ .

The various types of water demand, which a city may have, may be broken down into which of the following classes? 
1. Domestic water demand 
2. Industrial water demand 

3. Demand for public uses 
Select the correct answer using the codes given below: 

Gravity model is used in transportation planning process for

Bituminous materials are used in highway construction primarily because of their 

Average illumination on important roads as per I.S. recommendation is 

The width of the rib of a T-beam is generally kept between

Which of the following is the purpose of the valuation?

Calculate the combined correction for curvature and refraction (in m) for a distance of 2 km.

When timber is burnt in the wood fire over a depth of about 15 mm, the process of treatment is known as

Distribution reinforcement in a simply supported slab is provided to distribute

Reciprocal levelling eliminates:-

The ratio of hydrostatic stress to the volumetric strain within the elastic range is called

Pick up the correct statement from the following

Working out the exact quantities of various items of work is known as

Which of the following statement is not correct for the principle of surveying?

Which one of the following statements is correct

The depth of foundation is usually calculated from

Which of the following property of ordinary Portland cement is improved by the pozzolana?

Detailed plotting in plane  table surveying is generally done by

Under which of the following circumstances can the contour lines of different elevations intersect each other?

If S_b is the average bond stress on a bar of diameter d subjected to maximum stress t, the length of the embedment l is given by

__________ is used to ensure that the thickness of plastering is uniform.

Which of the following is the reason for the decrease in the use of stones as building material

In a theodolite the line of collimation is

A hollow shaft is subjected to torsion. Which of the following diagrams shows the shear stress variation in the shaft along its radius

Optimum moisture content is obtained from

Stadia interval factor is:

Which of the following methods of contouring is most suitable for hilly terrain?

Which of the following is the correct assumption of the Kennedy's theory?